Performance Leader

The microprocessor-controlled voltage stabilizers control the output voltage at all times and produce speed control signals with high sensitivity that help to regulate the output voltage of the stabilizer.

High Efficiency up to 98%

Trans-san produces all of its stabilizers in accordance with the high efficiency principle. The losses are almost non-existent.

Overvoltage Protection Unit

The stabilizer provides an output of 380 Volts (400 Volt 1) within the input voltage range of 275/450 Volts, the mains voltage below or above this range causes deviations in the stabilizer output. The Overvoltage Protection Unit is then activated and blocks output. In cases where one or two phases are lost, the unit blocks the output for the devices that are sensitive to three-phase and protects the devices connected to the system.

True RMS Voltage

Voltage stabilizers operate according to the true RMS voltage value.

Humidity Resistant

It operates without any problems even at a humidity level of 90%.

High Voltage Check

The processor checks the output voltage 200 times a second.

Fast Reaction

The processor regulates a voltage change of 200 Volts in less than one second. 2

Full Efficiency under any Climate Conditions

Either located in boiling hot Dubai or freezing cold Alaska, this is not an obstacle for your Trans-san stabilizer. It operates under any climate conditions between +45 and -25.

IP20 Protection

Trans-san offers protection against any objects with a diameter larger than 12,5 mm. Access of any objects with a diameter of this size to dangerous sections are prohibited.

Shipment to the Whole World

The quality-certified high-quality products of Trans-san that has shipped products to more than 30 countries since 1975 can be shipped anywhere you like.

With Full Microprocessor

The stabilizer is designed with a full microprocessor and feeds the online system.

Prevents Emission

The stabilizer stays within the tolerance range of the servo engine control cards with microprocessor software so there is no out-of-tolerance emission.

Different Voltage Output Options

The stabilizer output voltage could be set according to the desired voltage values such as 400-415 Volts for the devices produced for different countries.

Mechanical By-Pass

It is possible to transfer the load directly onto the mains or via the SVR by a mechanical by-pass through a rotary switch.